I have a simple circuit for a power-over-ethernet power supply, and would like the PCB Layout completed for the circuit. It is a simply circuit that is comprised of only 15 components including bridge rectifiers, coil, resistors, capacitors, header connector, and RJ45 jack. It is actually just a host board which another daughter board will connect via the header connectors.
I am very out of practice with PCB layout, and would appreciate someone to create the PCB layout based on the attached schematic and BOM. I would also like a prototype board build and assembled, which I can supply all of the components.
I am attaching the schematic, Bill Of Materials, and the manual for the EVAL-AG5500 board which is the reference design for this PCB.
The board footprint will be max 55.5mm x 90mm with no mounting holes; it will be installed in the aluminum PCB case which I've attached the TEKAL-12 dimensions for your reference. I've also attached an updated version of the BOM in PDF format.
I am attaching the package dimensions of the AG5500 module, which is the daughter board that will connect via the header connectors on this PCB. This will give you the location and spacing for the 6way and 9way SIL header connectors.
There are (2) RJ45 ports and (1) DC Jack, which all will be co-located on the same end of the PCB (either left or right) aligned flush with the edge of the board.
The scope of the project is to layout and then build/assemble a prototype of the board. I will pay for the PCB fabrication and all components, of which I already have all of the components listed on the BOM and can send to you for assembly. You are welcome to select the PCB build shop and send the approved layout out for fabrication, which I will pay for boards.
I will pay a 50% milestone upon PCB Layout completion and approval, and pay the remaining 50% upon delivery of the assembled prototype.
20 freelancers are bidding on average $504 for this job
20+ years experience in PCB layout, EaglePro is currently being used. Example layouts can be seen at [url removed, login to view] See PM for additional
I am an experienced PCB designer. I use the Pro version of EAGLE v4.16r2 and v5.11. I have designed digital, mixed signal and analog boards. This is a simple board.
10 plus years as hardware design engineer. Comfortable with Altium, PADs and Cadstar. Worked on projects from 8-bit Micro-controller to the recent [url removed, login to view] based designs.
I am an Layout PCB Engineer located in Mexico with a very good experience in PCB design, shematics, Bill materials, gerber files. My refereces is products of consum and equipament audio,medical,supply power
I provide full Design, Production Package, 3D Models, and Assembly. I use ALTIUM and Solidworks for modeling to insure electrical and mechanical designs. I have attached a 3D Model of a POE in PM