The candidate will have to study the existing software, eventually modify the software and finally run the machines to final customer.
To reach this target he/she must have real experience in developping software and run machine in fully automated handling plant.
The machine he/she will deal with are:
• cranes controlled by servo driver
• conveyors with all their equipment (tag reader, weighing machines, smart photocells for diameters...)
• cartesian robot controlled by servo drivers .
• Real experience of programming complex logic and sequence for Handling machines sector.
• Good knowledgment of TIA Portal for PLC programming especially in LAD and SCL language.
• Good knowledgment of TIA Portal for HMI programming .
• Good knowledment of Siemens integrated Safety PLC.
• Good knowledgment of Inverter / Drivers (position control and speed control- parametrization and optimization) of Siemens Brand .
• Good knowledgment of Profinet bus .
The real knowledgement of the candidate will be tested by pratical execize where a program will have to be develop in SCL and LAD language, an HMI will be develop and a driver in positioning mode will be configured starting from motor plate and cinematic sheet.
23 freelancers are bidding on average €37/hour for this job
Hi sir I m plc programmer I have good knowladge TIAPORTAL and i have done many project about it I used s7-1200,s7-1500,s7-300,s7-400 I have also drive programming experience G120c and s120 drives i know very well