I would like an .stl file that I could use to print on my 3D printer (PLA). I am looking for a model that is all one piece, freestanding, stands approx. 9 inches tall with proportional width and looks like an ear of corn with feet (think Mr. Potato head feet except these feet would be permanently attached) and a head (with eyes, lips and possibly a nose if the nose doesn't work that is optional) with the name LARRY across the chest in raised letters. I am including a sketch. Please note, I am not a good artist so PLEASE take creative liberties to make it better. I am hoping the husk has some texture to it so it is more realistic. The husk can’t stick out too far from the cob because the 3D printer couldn't handle it. Although I suppose I could use supports if need be. I would like the kernels & husk to look as realistic as possible. Obviously the feet and face add a silliness it. A short back story, my Brother has had the nickname Larry Korn for many years. He was recently in a terrible car crash which will take a long time to recover from. He just woke up from being unconscious for 2 1/2 weeks. There has never before been a physical representation of "Larry". So I am hoping it looks awesome (I will paint it) and it will go in his hospital room to bring some levity to his situation. I am attaching a pic of an ear of corn that looks like it may be a good model to work from as well as my poorly drawn pic. - Thank you in advance.