Stm32f3discovery project jobs
I'm looking for a firmware engineer who can save me a bit of time writing a very small C based project using existing software examples provided by the micro controller manufacturer. This project is to develop a C source code example demonstrating switch based control of loading one of three of the ST Microelectronics supplied USB device drivers. Basically, depending on the switch that is enabled, the project would load either a HID, CDC comm port, or DFU driver. The microcontroller target is the STM32F303 and your work would be confirmed and must run on the STM32F3DISCOVERY. Here are specific requirements: - The software shall be developed to run on the STM32F3DISCOVERY development board. - The software shall utilize the current revision STM...
Hi, We need someone that implements on the STM32F3Discovery this functions and give us a code well documented and commented. The key points and key features are: 1) Project developed with Atollic studio 2) Send the sensors data through a Virtual Serial Port. 3) The output format from the serial port should be compatible with multiwii software. 4) Support for LPS331AP barometer or another at your choice. 5) GPS module support. The Gps module can be suggested by the freelance, details about it will be given after the bids are complete. 6) Save the data from all the sensors on the board and the GPS and the baromiter values on an external SD card (micro SD card). 7) Use of known library for SD card filesystem 8) Bluetooth module support for sending the same data ...
Hi, We need someone that implements on the STM32F3Discovery this functions and give us a code well documented and commented. The key points and key features are: 1) Project developed with Atollic studio 2) Send the sensors data through a Virtual Serial Port. 3) The output format from the serial port should be compatible with multiwii software. 4) Support for LPS331AP barometer or another at your choice. 5) GPS module support. The Gps module can be suggested by the freelance, details about it will be given after the bids are complete. 6) Save the data from all the sensors on the board and the GPS and the baromiter values on an external SD card (micro SD card). 7) Use of known library for SD card filesystem 8) Bluetooth module support for sending the same data ...
Hi, We need someone that implements on the STM32F3Discovery this functions and give us a code well documented and commented. The key points and key features are: 1) Project developed with Atollic studio 2) Send the sensors data through a Virtual Serial Port. 3) The output format from the serial port should be compatible with multiwii software. 4) Support for LPS331AP barometer or another at your choice. 5) GPS module support. The Gps module can be suggested by the freelance, details about it will be given after the bids are complete. 6) Save the data from all the sensors on the board and the GPS and the baromiter values on an external SD card (micro SD card). 7) Use of known library for SD card filesystem 8) Bluetooth module support for sending the same data ...
