Electronics PCB

This is a new job to modify an existing Printed Circuit Board. It is to make the version 3. KNOWLEDGE Mandatory: The person must know and use 16.3 cadence software. The person must know how to add components and the layout production rules. /KNOWLEDGE CONTEXT The aim of the job is to replace the actual 64 pin TQFP by a 100 pin TQFP and a 48 pin LQFP. The components have a minimum of dedicated passives. The PCB has 4 layers. On the top, the actual placement and layout must remain the same. On the bottom, there is a 64 pin TQFP with a minimum of dedicated passives. /CONTEXT Here is the description of the tasks: DESCRIPTION: A. Remove L1 and L2. B. Remove C3 and C4 capacitors. C. Add 0.1uF 0603 CER 16V 10% X7R capacitors. D. Add five 2.2kohm SMT, 2.2 KΩ 1/16W 1% 0603 resistors. E. Add one SMT, 0805 Green DIFF 2x1.25 mm led. F. Add one SMT, 510Ω 1/16W 1% 100 PPM 0603 resistor. G. Add one OSC SMT H. Add four SMT, 33Ω 1/10W 5% 0603 resistor. I. Add one IC 48-LQFP J. Add two SMT, 1.5 KΩ 1/10W 1% 0603 resistor. K. Add one SMT, 4.87 KΩ 1/10W 1% 0603 resistor. L. Replace U1 by one 100pin TQFP. M. Remove R27, R28. N. Replace C22 and C23 by two SMT, 20 pF 0603 CER 50V, 5% C0G capacitors. The package 0603 stays the same. O. Replace Y1 by one OSC SMT P. Replace C17 by one SMT, 10 µF 0805 CER 6.3V 20% , X5R capacitor. The package 0805 stays the same. Q. Add one switch /DESCRIPTION INPUTS To do it, the inputs are: Cadence files BOM (excel file) Schematic Description of the tasks /INPUT OUTPUT The outputs are: Schematic, it is a milestone it is a checkpoint -> Payment BOM (generated by the software) it is a milestone it is a checkpoint -> Payment Layout it is a milestone it is a checkpoint -> Payment Gerber files, placement and coordinates -> It is a milestone it is a checkpoint. Payment Cadence files -> Payment /OUTPUT REPLY To reply, the priority will be given to low cost proposal. /REPLY