14D439 Solidworks Drafting
$30-250 USD
Paid on delivery
the work required is as follows:
* review the 7 attached documents.
* bid on the job.
* draw the basic servo cylinder
* draw a flange based on the setout on the drawings and the approx measurements below.
* restrain the flange and apply a 250 bar pressure (use 250 MPa steel).
* increase the thickness of the flange till the stresses are under yield point.
* document in drawing template and PDF.
Approx. Dimensional Summary:
Inside Diameter: 420mm
Spigot Diameter: 430mm
Bolt PCD: 615mm
Flange OD: 705mm
No. Bolts: 16
Hole Size: 46mm
A key requirement is for the o-ring to sit on the newly installed sleeve, that means it must sit between approx 430mm ID and 450mm OD to prevent any water ingression between the liner.
Project ID: #7036873
About the project
Awarded to:
3 freelancers are bidding on average $151 for this job
looking forward to have your private message. -------------------------------------------------------------------------------------