PCB Schematic and Layout for a GPS Tracker with Camera

Hello, If you are invited to here then please apply. It is not an error. I require someone who can build a PCB schematic and take care of everything regarding the project (hw, fw, ..). I need a GPS tracker that can report the following every 5 seconds to a web services: - The location and speed. - Accelerometer values in 3d. - Discoverable Bluetooth devices nearby. - Car engine state (a 12v on/off signal). - Can connect to up to 3 external cameras using cables. - Can connect 3 accelerometers. It should be also able to capture pictures and video streams on high acceleration values; or on demand (Server returns a command to the device). I expect the following: 1- HW design for (Bluetooth, GSM/GPRS, GPS, Accelerometer, battery, Processor, Camera). 2- Firmware. 3- Mechanical design (case and cooling), and all needed manufacturing documents. 4- Tested prototypes. Cost of components is outside the bid. 5- A fully tested product. Device will reporting to the tracking server using GSM/GPRS. It will user HTTP GET/POST protocols. Device will also contains the following: - SDCard to buffer captured images and videos before send; and for logging and to save reported information in case of no communication. - Backup internal battery good for at-least 5 hours of operations. - DIP switch to control the debugging, and other features. - Standard debug port - Surface mount leds to signify - GSM Network Status , Bluetooth status, stm32 ,power, etc - Internal antennas; with external connectors for an addon external antenna. The main power source will be the car battery. External dimensions should not exceed 15cmX10cmX1cm. I expect to build 2 to 4 prototypes. Product is to run in USA; and should comply with its networks standards on all states. I do not expect to pay upfronts. First milestone to go when schematic is proven with a running testing firmeware, and the processor can communicates with every module correctly.